BMW - 3.0 - 258-BHP - 192-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 258 | 278 | 306 |
| Torque (Nm) | 300 | 320 | 352 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (02/2010 - 01/2013) |
| Model: 530i |
| Fuel: Petrol |
| Engine: 3.0 - 258-BHP - 192-KW |
| Chip Tuning: N52B30O0 |
Ecu Information
| Engine Ecu: SIEMENS MSV80 |
| Reading Devices: Above pedals |
| OBD: ENU_MO_0202 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 202 |
| Protocollo KTAG: 990 |
| Processore KTAG: Boot(Tricore) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD/Boot |
| CMD: OBD Only |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: YES |
| HARDCUT: NO | POP & BANG: YES |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: YES |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
