BMW - 3.0 d - 218-BHP - 163-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 218 | 260 | 286 |
| Torque (Nm) | 500 | 580 | 638 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (01/2004 - 03/2007) |
| Model: X5 30d |
| Fuel: Diesel |
| Engine: 3.0 d - 218-BHP - 163-KW |
| Chip Tuning: M57D30TU |
Ecu Information
| Engine Ecu: BOSCH EDC16C31 |
| : Sealed all around, remove one side |
| Reading Devices: Behind panel, near boot release |
| OBD: ENU_094300CAN1 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 159 |
| Kess V2 Aiuto: ENU_L_EDC16 |
| Protocollo KTAG: 3 |
| KTAG Aiuto: ENU_L_EDC16 |
| Processore KTAG: Bdm(MPC5xx) |
| AUTOTUNER: OBD Only |
| X17: OBD Only |
| CMD: OBD/Boot |
Available Solutions
| DPF: YES | EGR: YES |
| ADBLUE: NO | TVA: YES |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: YES | POP & BANG: NO |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: YES | BOOST SENSOR: YES |
| SPORT DISPLAY: NO | SWIRL FLAP: YES |
| LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
