BMW - 2.5 - 204-BHP - 152-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 204 | 225 | 248 |
| Torque (Nm) | 250 | 265 | 292 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (01/2009 - 01/2013) |
| Model: Z4 23i Roadster |
| Fuel: Petrol |
| Engine: 2.5 - 204-BHP - 152-KW |
| Chip Tuning: N52B2501 |
Ecu Information
| Engine Ecu: SIEMENS MSV80 |
| Reading Devices: Kick panel, driver's side |
| OBD: ENU_MO_0202 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 202 |
| Kess V2 Aiuto: ENU_L_SIEMENS_MSVxx_BMW_SSM |
| Protocollo KTAG: 990 |
| KTAG Aiuto: ENU_L_SIEMENS_MSVxx_BMW_SSM |
| Processore KTAG: Boot(Tricore) |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD/Boot/Bench |
| CMD: OBD/Boot/Bench |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: NO | EVAP: YES |
| HARDCUT: NO | POP & BANG: YES |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: YES |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
