BMW - 2.0 - 150-BHP - 112-KW
Estimated %30 more power and %40 more torque
| Parameters | Original | Stage 1 | Stage 2 |
|---|---|---|---|
| Power (Hp) | 150 | 164 | 180 |
| Torque (Nm) | 200 | 225 | 248 |
Vehicle Information
| Vehicle: cars |
| Brand: BMW |
| Year: (01/2003 - 01/2006) |
| Model: Z4 Roadster |
| Fuel: Petrol |
| Engine: 2.0 - 150-BHP - 112-KW |
| Chip Tuning: N46B20 |
Ecu Information
| Engine Ecu: BOSCH MEV9.2/MEV946 |
| Reading Devices: Behind panel, near boot release |
| OBD: ENU_094300CAN1 |
Reading Devices
| KESSV2: OBD |
| Kess V2 Protocollo: 216 |
| Protocollo KTAG: 103 |
| Processore KTAG: Freescale MPC5xx |
| AUTOTUNER: Not yet supported - Check tool |
| X17: OBD Only |
| CMD: OBD/Boot |
Available Solutions
| DPF: NO | EGR: NO |
| ADBLUE: NO | TVA: NO |
| HOT START: NO | SAP: NO |
| DTC: YES | EVAP: NO |
| HARDCUT: NO | POP & BANG: YES |
| EXAUST FLAP: NO | GPF OFF: NO |
| TQM: NO | SPEED LIMIT: YES |
| START STOP: NO | LAMBDA: NO |
| MAF: NO | BOOST SENSOR: NO |
| SPORT DISPLAY: NO | SWIRL FLAP: NO |
| LAUNCH CONTROL: NO |
Note 1
If push button ignition please follow these steps. 1. hold button for 4 seconds and release. Dash should illuminate, if it doesn?t press once more. Onnce dash illuminated proceed to read/write. When kess prompts to cycle ignition just ignore and select next. Without doing this will still read but fail on write
